Garmin Step Speed Loss (SSL)

Home » Garmin Features » Running Dynamics » Step Speed Loss (SSL)
Accuracy
Unvalidated; no published study has tested Garmin’s step speed loss
Best for
Spotting overstriding and low cadence on flat road runs
Weakness
Needs an HRM 600, and its colour bands do not allow for pace

Plain English: Each time a foot lands, a runner brakes slightly before pushing off again. This figure measures how much forward speed is lost in that moment, in centimetres per second, and a percentage version scales it to running speed. A lower number means less braking and less work to get back up to speed, while a higher number usually goes with overstriding or a low cadence.

In practice: This is another superficially interesting metric that initially appears to reflect a fundamental aspect of your technique that you might improve to become more economical. Training that to happen is probably easier for a poorer runner, where simply increasing cadence is likely to reduce step speed loss and, when combined with other efficiencies, make you faster.

Quick answers

What is step speed loss on a Garmin?
Step speed loss is how much a runner slows down when each foot hits the ground, measured in centimetres per second by the HRM 600 chest strap. A percentage version expresses the loss as a share of running speed.


What is a good step speed loss?
Lower is better. Garmin’s colour gauge compares a reading with other runners: under 8.2 cm/s is purple, the top 5%, and over 25.9 cm/s is red, the bottom 5%. The gauge uses the raw figure, which rises with speed, so the fairest comparison is against your own runs at a similar pace.


Which Garmin watches support step speed loss?
Step speed loss needs an HRM 600 paired in secure Bluetooth mode and a watch whose manual lists the metric. It launched on the Forerunner 970, and Garmin’s manuals also list it for Fenix 8, Fenix 9, Fenix E, Enduro 3, Enduro 4, D2 Mach 2, Venu X1, Quatix 8 and Tactix 8.


Why is my Garmin step speed loss not showing?
The usual cause is an HRM 600 paired over the open connection instead of the secure Bluetooth connection, and a strap worn upside down is the other common fault. The metric is also not calculated while walking.


Step speed loss – a deep dive

When step speed loss is actually useful

I find this metric interesting but not useful. It’s interesting to see how it varies when shoes are changed or when running in different conditions. If you read the rest of this article you will see that those interesting things are not the correct things to do for true comparisons!

I can run with a rearfoot, forefoot or midfoot gait. Unsurprisingly, forefoot striking reduces SSL at the same speed.

Like many of you I probably run at a higher speed and cadence on race day. Unsurprisingly SSL improves.

Introduction

Step speed loss (SSL) is, in Garmin’s words, “how much you slow down when your foot hits the ground while running”, and it is measured in centimetres per second. Garmin’s running science page describes it as the difference between a runner’s forward speed at first contact and the minimum forward speed that follows. Garmin also offers step speed loss percent, which expresses the same loss as a percentage of running speed because the raw figure typically rises as a runner goes faster.

Garmin introduced the metric in May 2025 with the HRM 600 chest strap and the Forerunner 970, and it sits in the Running Dynamics suite alongside cadence, ground contact time, vertical oscillation and stride length. It is also an input to Garmin’s Running Economy metric. No study has validated Garmin’s step speed loss, so the number is best read as a trend for one runner.

What step speed loss actually means

A lower number is better. Garmin says it “indicates you have to do less propulsive work to speed back up”, because less forward speed was lost to braking on landing. A higher number means more braking with each step, and Garmin links that to running with a lower cadence or overstriding. Garmin includes step speed loss in its running dynamics colour gauge, which places a reading against other runners by percentile. Garmin links the purple, blue and green zones with more experienced or faster runners, and the red and orange zones with less experienced or slower ones. The gauge uses the raw cm/s figure, which rises with speed, and Garmin publishes no age or sex norms.

Colour zone Percentile Step speed loss (cm/s)
Purple Above 95 Under 8.2
Blue 70 to 95 8.2 to 12.1
Green 30 to 69 12.2 to 19.7
Orange 5 to 29 19.8 to 25.9
Red Below 5 Over 25.9

Source: Color Gauges and Running Dynamics Data, Garmin Forerunner 970 owner’s manual.

How Garmin calculates step speed loss

Garmin states that step speed loss is the difference between forward speed when the foot first hits the ground and the minimum forward speed during that contact, and that it is measured “at the chest by the heart rate monitor in units of cm/s”. On hills, the barometer in the watch detects the grade, which lets the metric account for the effect of gravity, according to Garmin’s step speed loss page. Garmin does not publish the method; the most plausible derivation is that the HRM 600 integrates its fore-aft acceleration within each step. The averaging window behind the live data field is unknown.

On a treadmill the incline is not accounted for. The metric is not calculated while walking, and Garmin says it may not be computed during turns or on variable surfaces such as technical trail.

What affects the step speed loss reading

Running form has the clearest effect: Garmin says a lower cadence or overstriding tends to increase step speed loss. Speed raises the raw figure too, which is why the percentage version exists. On terrain, step speed loss is typically lower uphill and higher downhill outdoors, where the barometer correction applies.

How accurate is Garmin step speed loss

Garmin publishes no accuracy figure, and no study has validated Garmin’s step speed loss. The closest published measure is the minimum horizontal pelvis velocity during ground contact, which Folland and colleagues found to be among three technique variables that together explained 39% of the variation in energy cost across 97 runners. That supports the idea behind the metric, not the strap’s measurement of it.

Absolute values should not be compared between runners. Changes in one runner’s numbers on the same route at a similar pace, with the same strap, are the more reliable use.

Competitor equivalents

  • Polar does not offer an equivalent braking metric.
  • Apple Watch does not offer an equivalent braking metric.
  • COROS has no equivalent, although its Running Form Test with the COROS POD reports ground time, strike angle, stride ratio, leg stiffness, peak ground reaction force and balance.
  • Suunto does not offer an equivalent braking metric.
  • STRYD has no equivalent. Its Leg Spring Stiffness models the leg as a spring from the peak vertical force and the vertical drop during ground contact, and its Impact Loading Rate measures how quickly vertical force builds as the foot lands. Both describe vertical forces, while step speed loss describes horizontal braking.
  • Fourth Frontier has no equivalent. Its Body Shock looks at the body’s reaction to each landing through the strap’s ECG, rather than measuring lost forward speed.

Which Garmin devices support step speed loss

Step speed loss needs an HRM 600 paired over the secure Bluetooth connection and a Garmin watch whose manual lists the metric. Garmin introduced it in May 2025 on the Forerunner 970. As of November 2026, Garmin’s owner’s manuals list it for Forerunner 970, Fenix 8 series (including Fenix 8 Pro), Fenix 9 series (including Fenix 9 Pro), Fenix E, Enduro 3, Enduro 4, D2 Mach 2, D2 Mach 2 Pro, Venu X1, Quatix 8 and Tactix 8. The Fenix 8 and Enduro 4 manuals give its sensor type as “HRM 600 only”. The Forerunner 965 and Fenix 7 generation manuals do not include it.

Where to find step speed loss on Garmin

  • Live data fields: step speed loss and step speed loss percent, plus lap versions of each, can be added to a run data screen on a supported watch, and the running dynamics colour gauge can show step speed loss.
  • Garmin Connect: both appear as post-run time-series charts in the activity detail.

Common problems and misreadings

Missing data usually comes from the pairing mode or the strap’s orientation. See Quick answers above.

A blank field is expected when walking, turning or crossing technical ground, because Garmin does not compute the metric then.

Comparing raw step speed loss across runs at different paces is the other common misreading, because a faster run usually shows a higher figure with no change in form. Treadmill readings on an incline are not comparable with outdoor hills either.

How to improve step speed loss

Garmin’s cues are to run smoothly and lightly and to reduce step length. Chen and colleagues found that larger peak braking forces went with a higher energy cost in recreational runners, which supports aiming for less braking.

Progress is best judged on the same flat route over several weeks, using the percentage version.

Scientific basis

Folland, J.P., Allen, S.J., Black, M.I., Handsaker, J.C. and Forrester, S.E. (2017). Running technique is an important component of running economy and performance. Medicine and Science in Sports and Exercise, 49(7), 1412 to 1423. PMID 28263283. In 97 runners, minimum horizontal pelvis velocity during contact, the closest published analogue to step speed loss, was one of three variables that together explained 39% of the variation in energy cost.

Chen, S., Segers, V., Zhang, Q., Zhang, Q., Ding, H. and Li, F. (2024). Lower extremity kinematic and kinetic characteristics as effects on running economy of recreational runners. Medicine and Science in Sports and Exercise, 56(8), 1368 to 1377. PMID 38547400. In 30 recreational male runners, a larger peak braking force correlated with a higher energy cost at 10 to 12 km/h.

How step speed loss connects to other Garmin features

Step speed loss describes horizontal braking, and it is read best alongside cadence and stride length, since overstriding and a low cadence are what Garmin says push it up. Ground contact time and vertical oscillation describe the time on the ground and the bounce, while step speed loss describes the speed lost on landing. It feeds Garmin’s Running Economy metric. Related pages cover Running Power and Running Tolerance.


Small things I always use

Health, recovery and sleep

  • Kineon MOVE+: Red and infrared light for sore knees, Achilles and other joints after hard training. I use it.
  • FreeStyle Libre 3 Plus: Shows how my blood sugar responds to diet. Occasional use.
  • hDrop: Measures my sweat loss in summer and indoors. I use it.
  • Fourth Frontier Zone: Checks my heart under load in hard sessions.
  • Oura Ring 5: My partner’s recovery tracker of choice.
  • Eight Sleep: A cooling mattress cover my partner and I use nightly.

Watches and sensors

On the bike

Home and indoor training

  • NPE Runn: Makes my basic treadmill smart, sending more accurate speed and distance to my watch and Zwift. I use it.
  • Google Wifi: Keeps Zwift connected in my pain cave. I use it.
  • Apple TV 4K: Zwift on the big screen. I use two.
  • Google Nest Doorbell (wired, 2nd gen): My video doorbell, running in both Google Home and Apple Home via Starling. I use it.


Reader-Powered Content

Buy me a coffee

This content is not sponsored. It’s mostly me behind the labour of love, which is this site, and I appreciate everyone who supports it.

Support the site: Follow (free, fewer ads) · Subscribe (paid, ad-free) · Buy Me A Coffee

Written by real people, with AI assistance. Fact-checked and verified for originality. See the Editorial Policy. FTC: Affiliate Disclosure — some links pay commission. As an Amazon Associate, I earn from qualifying purchases.