Garmin Acute Load

Home » Garmin Features » Training » Acute Load
Accuracy
No independent validation, so it is only as good as the heart rate behind it
Best for
Judging whether this week is heavier or lighter than the athlete’s recent norm
Weakness
Heart rate-based, so intervals, strength work and sessions without heart rate data can mislead

Plain English: Garmin keeps a running total of how hard the last week of training has been on the body, and recent sessions count for more than older ones. The gauge compares that total with a range based on the athlete’s fitness and training history. Inside the range is a normal week, below it is light and above it is heavy.

In practice: Acute load is one of the first layers of metrics that Garmin uses to interpret your heart rate during exercise and model its short-term impact. The model is highly susceptible to bad data if your optical heart rate monitor is inaccurate or if you don’t record training sessions. Even when the data is correct, you should look at the mix of hard and easy workouts, using Load Focus and Load Ratio, to make training decisions.

Quick answers

What is a good acute load on Garmin?
A good acute load is one inside the optimal range shown on the gauge, which Garmin sets from the athlete’s own fitness level and training history. The same number can be optimal for one runner and very high for another, so no fixed figure applies to everyone.


Why did my Garmin acute load drop after a rest day?
Each session’s influence fades over about ten days, so a day without training lowers the total even if nothing else changes. After several rest days the gauge can fall into the low zone, and the first normal session back can push it into the high zone because the baseline has decayed.


Does Garmin acute load count strength training?
Only partly. The load comes from heart rate through an estimate of excess post-exercise oxygen consumption (EPOC), which reflects mainly aerobic effort, so a strength session can leave an exhausted athlete with a low figure. Sessions with no heart rate data contribute reduced or no load.


Is acute load the same as training load on Garmin?
They are related but not identical. Older watches showed Training Load as a simple seven-day sum of EPOC, and current Garmin software uses acute load, a weighted figure in which older sessions fade rather than drop out after seven days.


Acute Load – a deep dive

When acute load is actually useful

This information is not very useful in itself, but it is a useful input to other, more actionable Garmin metrics.

Introduction

Garmin acute load is, in Garmin’s words, “a weighted moving average designed to reflect the strain placed on your body on a weekly basis”. Each recorded activity is added in full and then fades over the next ten days, and the total is normalised to a seven-day window. The result sits on a gauge against an optimal range, and Garmin’s own Training Status page describes it as a weighted sum of EPOC for the last several days.

Acute load is the weekly input to Training Status and Training Readiness. Its limitation is the chain behind it: heart rate becomes an EPOC estimate and then a load figure, so any heart rate error carries straight through, and no independent study has validated the result against a laboratory reference.

What acute load actually means

A high acute load means recent training has been heavy relative to what the athlete’s fitness and history support, and a low one means it has been light. Garmin sets the optimal range from the athlete’s fitness level and training history, so the range rises for athletes who train consistently at higher volumes and falls during quiet periods. Garmin shows the status as low, optimal, high or very high and publishes neither the formula for the boundaries nor any age or sex norms. The number is a measure of recent strain, not of fitness.

How Garmin calculates acute load

Garmin states that each activity’s load is “added in full to your current acute load”, that its influence “gradually expires during the next 10 days”, and that the combined total is “normalized to reflect a 7-day window”. Garmin attributes the underlying EPOC estimate to the Garmin Human Performance Lab engine (formerly Firstbeat) and says it is predicted from heartbeat data using mathematical modelling and machine learning. Firstbeat’s published EPOC model estimates oxygen cost from heart rate intensity relative to VO2 max, and that is the most plausible basis for the current figure, but Garmin does not say the two are identical.

Garmin does not publish the weighting curve, the way the optimal range is computed, or how activities without heart rate are treated. An activity without heart rate data is likely to contribute reduced or zero load, which is an inference from the heart rate dependence rather than a Garmin statement. Older watches used a simple seven-day sum, so the same week can read differently across software generations.

What affects the reading

Heart rate accuracy is the biggest factor. A wrist sensor that misreads during intervals, in the cold or through cadence lock gives a wrong EPOC for that session, and a chest strap generally produces more consistent values for hard efforts. Activity type matters too: long moderate sessions accumulate substantial EPOC per hour, while short intense intervals with full recovery can score less than they feel, and a 12-hour low-intensity hike can match a hard tempo run.

Heat, altitude and fatigue raise heart rate for a given pace, which raises the estimated load, and in most cases that reflects real cardiovascular strain. Rest days lower the figure as older sessions fade, which is expected behaviour. Imported activities from third-party platforms often carry no EPOC and contribute nothing.

How accurate is Garmin acute load

No independent peer-reviewed study has validated acute load against a laboratory reference. The nearest evidence is Firstbeat’s own EPOC model, which its white paper reports at an r-squared of 0.79 against measured EPOC in a cycling study by the group that developed the model, and no independent running validation has been located.

Accuracy therefore follows the inputs. A steady run recorded with a chest strap is likely to give a proportionate figure, and wrist intervals may give a materially wrong one. Trend reliability is better than single-session accuracy, because over a week of mixed sessions overestimates and underestimates partly cancel. The gauge works as a week-on-week comparison and not as a precise physiological measurement.

Competitor equivalents

  • Polar uses Cardio Load, a heart rate based TRIMP measure, and its Strain value is the seven-day average that forms the acute side of Cardio Load Status.
  • Apple Watch has Training Load from watchOS 11, built from an effort rating of 1 to 10 multiplied by duration and compared with a 28-day baseline.
  • Coros calculates Training Load per activity from heart rate and, for some running, pace, and its Load Impact is a seven-day rolling figure.
  • Suunto derives a Training Stress Score per workout and a Fatigue figure from a weighted seven-day average.
  • Stryd builds its load figures from running power rather than heart rate.

The main difference is the input: Garmin models oxygen cost from heart rate, Polar and Coros use TRIMP-style heart rate weighting, and Apple blends in a subjective effort rating.

Which Garmin devices support acute load

Acute load is available on any Garmin that supports Training Status, and it replaced the older seven-day Training Load beginning with Forerunner 255 and Forerunner 955 in mid-2022. Edge cycling computers show an acute load figure for rides. Garmin’s page for each model shows whether the full gauge with its optimal range is included.

Where to find acute load on Garmin

  • Training Status widget: the current value, the coloured optimal range and the low, optimal, high or very high label.
  • Load glance: available on newer watches such as Forerunner 970 and Fenix 9.
  • Garmin Connect mobile: the current value, the optimal range and a trend graph under the performance stats.
  • Garmin Connect web: the same data with less interactivity than the app.

The value updates only after an activity is saved and synced, and it is not available as a live data field.

Common problems and misreadings

A sharp fall after two or three rest days is the weighting at work and not a fault. See Quick answers above.

Hard sessions that produce a small load are the commonest complaint. EPOC is mainly an aerobic measure, so short repeated sprints, strength sessions and any workout with poor heart rate tracking can score far below how they felt. See Quick answers above.

A high reading after an easy-feeling week usually comes from heat, a travel day with a long walk or an activity recorded twice. Checking the activity list for duplicates and the heart rate trace for spikes finds most causes.

How to improve acute load

Acute load is a measure of recent strain and not a fitness score, so the aim is to keep it inside the optimal range, not to raise it. A gradual build in weekly volume or intensity lifts the range itself over weeks, because the range follows the athlete’s history. Large jumps in a single week push the gauge into the high zone before the body has adapted, and deliberate easy weeks bring it back into range.

Scientific basis

Firstbeat, white paper “EPOC (Excess Post-Exercise Oxygen Consumption)”. Describes the heart rate based EPOC model behind Garmin’s load figures, including the validation against measured EPOC cited above and the point that EPOC reflects mainly aerobic properties of exercise.

How acute load connects to other Garmin features

Acute load sets the load side of Training Status and appears as a factor in Training Readiness. It is the weekly counterpart to the per-session score in Training Effect, and the older seven-day sum is covered on the Training Load page.


Small things I always use

Health, recovery and sleep

  • Kineon MOVE+: Red and infrared light for sore knees, Achilles and other joints after hard training. I use it.
  • FreeStyle Libre 3 Plus: Shows how my blood sugar responds to diet. Occasional use.
  • hDrop: Measures my sweat loss in summer and indoors. I use it.
  • Fourth Frontier Zone: Checks my heart under load in hard sessions.
  • Oura Ring 5: My partner’s recovery tracker of choice.
  • Eight Sleep: A cooling mattress cover my partner and I use nightly.

Watches and sensors

On the bike

Home and indoor training

  • NPE Runn: Makes my basic treadmill smart, sending more accurate speed and distance to my watch and Zwift. I use it.
  • Google Wifi: Keeps Zwift connected in my pain cave. I use it.
  • Apple TV 4K: Zwift on the big screen. I use two.
  • Google Nest Doorbell (wired, 2nd gen): My video doorbell, running in both Google Home and Apple Home via Starling. I use it.


Reader-Powered Content

Buy me a coffee

This content is not sponsored. It’s mostly me behind the labour of love, which is this site, and I appreciate everyone who supports it.

Support the site: Follow (free, fewer ads) · Subscribe (paid, ad-free) · Buy Me A Coffee

Written by real people, with AI assistance. Fact-checked and verified for originality. See the Editorial Policy. FTC: Affiliate Disclosure — some links pay commission. As an Amazon Associate, I earn from qualifying purchases.